TEADIT 24 BF is a non-asbestos gasket material made from pure virgin PTFE and
dimension-stabilizing filler material. The whole production process is subject
to strict quality control, registered under DIN EN ISO 9001.Application areas:
TEADIT 24 BF is particularly well suited for narrow sealing surfaces, high
assembly pressures, high operating temperatures, thermal cycling. It also
compensates well for out-of-parallel and/or damaged sealing surfaces.
Technical data:
Temperature range: - 240°C up to 260°C, for short periods up to 310°C
Chemical resistance: resistant against all chemicals from pH 0-13 except molten alkali metals and
elemental fluorine at high temperature and pressure.
Limited applicability
for highly concentrated caustic media at temperatures above 100°C
Pressure resistance:
vacuum up to 200 bar
Density: 1,0 g/cm3, +/- 0,1g/cm3
Aging resistance: TEADIT 24 BF does not age (please note: adhesive tape has limited shelf life!)
Colour: white
Others: TEADIT 24 B is physiologically
harmless. It has no smell or taste. It is neither
contaminating nor toxic. It fulfills the FDA 21 CFR
177.1550 Perfluorcarbon Regulations.
Product standard and recommended dimensions:
|
TEADIT 24 BF
dimension (mm) |
standard
flange size |
|
6 x 2,5 |
up to DN 600 |
|
8 x 3,5 |
from DN 600
up to DN 1200 |
|
10 x 5,0 |
DN 1200 and
larger |
TEADIT 24 BF is available on spools, with or without
self-adhesive strip.
When choosing the best suitable dimension of TEADIT 24
BF, one has to take the available bolt torque and possibly
damaged and/or out-of-parallel gasket surfaces into account.
+ quick and simple installation (please pay attention to
- and/or ask for - the installation instructions for TEADIT
24 BF)
+ reduced down time
+ no waste
+ no cost for gasket-cutting
+ long gasket life
+ low stock cost
+ unlimited shelf life (Please note: adhesive tape has
limited shelf life!)
pre-forming parameters KO x KD
at 6 bar KO x KD = 23 x BD (N/mm)
at 16 bar KO x KD = 28 x BD (N/mm)
at 40 bar KO x KD = 32 x BD (N/mm)
characteristic value under operating conditions K1
K1 = 2,5 x BD; BD = width under compression;
|
Disclaimer:
Since all
properties, specifications and application parameters shown throughout
this product information are approximate and may be mutually influenced,
your specific application should not be undertaken without independent
study and evaluation for suitability. All technical data and advice
given is based on experiences TEADIT
have made so far. Failure to select proper sealing products can result
in damage and/or personal injury. Properties, specifications and application
parameters are subject to change without notice. TEADIT &
Sealing Devices do not undertake any liability of any kind whatsoever.
Upon clicking through our product display range you acknowledge this disclaimer
as effective and binding.
|
